6218

HPS – High Performance Standard 6200 Series Single Row Deep Groove Ball Bearing

Item #100761659

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

I.D.	90 mm
Precision	Standard
Ball Material	Steel
Preload Level	None
Limiting Speed - Oil	4800 rpm
Inch/Metric	Metric Bore
Enclosure	Open
Inner Ring Width	30 mm
Seal Material	None
Contact Angle	0°
Material	Steel
Capacity	Standard Capacity
Bearing Type	Radial
Limiting Speed - Grease	4000 rpm
Width	30 mm
Corner Radius [Min]	2.00 mm
Static Load Rating [Max]	16,100.00 lbf
Snap Ring	No Snap Ring
Precision Level	Standard (ABEC 1)
Lubricant	Oil Preservative
Cage Material	Pressed Steel
O.D. Type	Straight
Radial Internal Clearance	Normal
Locking Device	No Locking Device
O.D.	160.0000 mm
Bore Type	Round Bore
Outer Ring Width	30 mm
Cage Type	Metal
Seal Type	Unsealed
Dynamic Load Rating	22,661.00 lbf
No. in Set	Single Bearing
Rows of Balls	Single
Radial Internal Clearance Specification	Normal Clearance
Weight	4.806 LB
EAN or UPC	29176015694