6220DDUC3

HPS – High Performance Standard 6200 Series Single Row Deep Groove Ball Bearing

Item #100761709

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

Snap Ring	No Snap Ring
Bearing Type	Radial
Static Load Rating [Max]	20,907.00 lbf
Limiting Speed - Grease	2400 rpm
Cage Material	Pressed Steel
Limiting Speed - Oil	4300 rpm
Ball Material	Steel
Rows of Balls	Single
Locking Device	No Locking Device
I.D.	100 mm
Inner Ring Width	34 mm
O.D.	180.0000 mm
Preload Level	None
Outer Ring Width	34 mm
Dynamic Load Rating	27,427.00 lbf
Lubricant	Mul-Temp SRL
Precision Level	Standard (ABEC 1)
Precision	Standard
O.D. Type	Straight
Inch/Metric	Metric Bore
icNumber	7696544
Width	34 mm
Radial Internal Clearance Specification	Greater Than Normal Clearance
Bore Type	Round Bore
No. in Set	Single Bearing
Capacity	Standard Capacity
Cage Type	Metal
Material	Steel
Seal Material	Buna-N
Enclosure	Double Sealed
Seal Type	Contact Seals
Corner Radius [Min]	2.10 mm
Contact Angle	0°
Radial Internal Clearance	C3
Weight	7.09 LB
EAN or UPC	29176064913