- Single Row Angular Contact Bearing, 50 mm ID x 130 mm OD x 31 mm Wide, Open, Standard Precision (ABEC 1), Brass / Bronze Cage, Normal Clearance (C0), 40° Contact Angle
features
- ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
- 7400-PJ and PJD Series bearings are similar to the 7200-PJ and 7300-PH Series but are heavier sectioned and are used for very heavy thrust loads or combined radial and thrust loads where thrust is predominant.
- 7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
- MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
- 7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
| Dynamic Load Rating | 21500 lbf |
| Radial Internal Clearance Specification | Normal Clearance |
| Radial Internal Clearance | Normal |
| Flush Ground | No |
| Snap Ring | No Snap Ring |
| Lubricant | Oil Preservative |
| Inch/Metric | Metric Bore |
| Seal Type | Unsealed |
| Seal Material | None |
| O.D. Type | Straight |
| Static Load Rating [Max] | 16200 lbf |
| Enclosure | Open |
| Ball Material | Steel |
| Static Load Rating | 64 kN |
| Inner Ring Width | 31 mm |
| Rows of Balls | Single |
| Capacity | Standard Capacity |
| Limiting Speed - Oil | 6400 rpm |
| I.D. | 50 mm |
| Cage Material | Brass/Bronze |
| No. in Set | Single Bearing |
| Origin | Single Row Angular Contact |
| Cage Type | Metal |
| Outer Ring Width | 31 mm |
| Series | 7400PJ |
| Material | Steel |
| Contact Angle | 40° |
| Width | 31.000 mm |
| Temperature Range [Max] | 450 °F |
| Limiting Speed - Grease | 4900 rpm |
| Precision | Standard |
| Locking Device | No Locking Device |
| Preload Level | None |
| O.D. | 130 mm |
| Precision Level | Standard (ABEC 1) |
| icNumber | 7695988 |
| Bore Type | Round Bore |
| Bearing Type | Angular Contact |
| Fillet Radius | 2 mm |
| Weight | 4.592 LB |
| EAN or UPC | 97741018432 |

