6207ZZC3

HPS – High Performance Standard 6200 Series Single Row Deep Groove Ball Bearing

Item #100761135

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

Snap Ring	No Snap Ring
Ball Material	Steel
Seal Material	Metal
Bore Type	Round Bore
icNumber	7696018
Width	17 mm
Precision Level	Standard (ABEC 1)
Inner Ring Width	17 mm
Precision	Standard
O.D.	72.0000 mm
Limiting Speed - Grease	9500 rpm
Dynamic Load Rating	5,778.00 lbf
Limiting Speed - Oil	11000 rpm
Seal Type	Non-Contact Seals
Locking Device	No Locking Device
I.D.	35 mm
No. in Set	Single Bearing
Rows of Balls	Single
Radial Internal Clearance Specification	Greater Than Normal Clearance
Bearing Type	Radial
Inch/Metric	Metric Bore
Cage Type	Metal
Static Load Rating [Max]	3,440.00 lbf
O.D. Type	Straight
Outer Ring Width	17 mm
Radial Internal Clearance	C3
Cage Material	Pressed Steel
Preload Level	None
Contact Angle	0°
Capacity	Standard Capacity
Corner Radius [Min]	1.10 mm
Enclosure	Double Shielded
Lubricant	Mul-Temp SRL
Material	Steel
Weight	0.635 LB
EAN or UPC	29176014734