6208DDUC3

HPS – High Performance Standard 6200 Series Single Row Deep Groove Ball Bearing

Item #100761206

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

Seal Material	Buna-N
Preload Level	None
Dynamic Load Rating	6,550.00 lbf
Enclosure	Double Sealed
Radial Internal Clearance	C3
Ball Material	Steel
icNumber	7695912
I.D.	40 mm
Cage Material	Pressed Steel
Material	Steel
Rows of Balls	Single
No. in Set	Single Bearing
O.D.	80.0000 mm
Radial Internal Clearance Specification	Greater Than Normal Clearance
Inner Ring Width	18 mm
Limiting Speed - Oil	10000 rpm
Contact Angle	0°
Snap Ring	No Snap Ring
Bore Type	Round Bore
Static Load Rating [Max]	4,010.00 lbf
O.D. Type	Straight
Limiting Speed - Grease	8500 rpm
Inch/Metric	Metric Bore
Precision	Standard
Locking Device	No Locking Device
Seal Type	Contact Seals
Width	18 mm
Corner Radius [Min]	1.10 mm
Lubricant	Mul-Temp SRL
Capacity	Standard Capacity
Cage Type	Metal
Precision Level	Standard (ABEC 1)
Outer Ring Width	18 mm
Bearing Type	Radial
Weight	0.802 LB
EAN or UPC	29176064371