6209DDUC3

HPS – High Performance Standard 6200 Series Single Row Deep Groove Ball Bearing

Item #100761270

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

O.D. Type	Straight
No. in Set	Single Bearing
Cage Material	Pressed Steel
Outer Ring Width	19 mm
Lubricant	Mul-Temp SRL
Dynamic Load Rating	7,081.00 lbf
Corner Radius [Min]	1.10 mm
Rows of Balls	Single
icNumber	7695913
Inch/Metric	Metric Bore
Snap Ring	No Snap Ring
Seal Material	Buna-N
Limiting Speed - Grease	5300 rpm
I.D.	45 mm
Radial Internal Clearance Specification	Greater Than Normal Clearance
Static Load Rating [Max]	4,586.00 lbf
Locking Device	No Locking Device
O.D.	85.0000 mm
Enclosure	Double Sealed
Precision Level	Standard (ABEC 1)
Radial Internal Clearance	C3
Bearing Type	Radial
Capacity	Standard Capacity
Ball Material	Steel
Preload Level	None
Material	Steel
Limiting Speed - Oil	9000 rpm
Cage Type	Metal
Precision	Standard
Seal Type	Contact Seals
Bore Type	Round Bore
Inner Ring Width	19 mm
Contact Angle	0°
Width	19 mm
Weight	0.924 LB
EAN or UPC	29176064425