6318C3

HPS – High Performance Standard 6300 Series Single Row Deep Groove Ball Bearing

Item #100761668

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

I.D.	90 mm
Bearing Type	Radial
No. in Set	Single Bearing
Bore Type	Round Bore
Cage Type	Metal
Precision Level	Standard (ABEC 1)
Enclosure	Open
Snap Ring	No Snap Ring
Lubricant	Mul-Temp SRL
Radial Internal Clearance	C3
icNumber	7696088
Seal Type	Unsealed
Corner Radius [Min]	3.00 mm
Inch/Metric	Metric Bore
Preload Level	None
Material	Steel
Outer Ring Width	43 mm
Static Load Rating [Max]	24,100.00 lbf
Inner Ring Width	43 mm
Cage Material	Pressed Steel
Rows of Balls	Single
Seal Material	None
Precision	Standard
Ball Material	Steel
Contact Angle	0°
Capacity	Standard Capacity
Limiting Speed - Grease	3600 rpm
Width	43 mm
Dynamic Load Rating	33,755.00 lbf
O.D. Type	Straight
O.D.	190.0000 mm
Limiting Speed - Oil	4300 rpm
Radial Internal Clearance Specification	Greater Than Normal Clearance
Locking Device	No Locking Device
Weight	10.827 LB
EAN or UPC	29176017735