Find a Service Center
- Spool Motor
- Gerotor
- Spool Valve
- 7/8-14 UNF-2B SAE O-Ring Port
- 2.81 Cubic Inch Displacement Per Rev
description
- Small but powerful, Eaton spool valve motors have the perfect combination of features for a variety of demanding applications, from harvesting equipment to food processing plants. With hydrodynamic journal bearings optimized for long life, these spool valve motors distribute pressurized fluid via integrated valve slots into the Gerotor or Geroler® orbit gear set. This results in a spool valve section that can be optimized for low-flow low-speed requirements, keeping equipment performing smoothly.
applications
- Agricultural augers, Harvesters, Seeders, Industrial sweepers and floor polishers
features
- Integrated proven orbit motor principle results in a compact yet powerful package
- Hydrodynamic journal bearings extend bearing life
- Three-zone pressure design allows for an increased shaft seal and bearing life
options
- SAE ports
- Splined and tapered shafts
| Output Torque at Rated PSI (inch/pounds) | 646 in lb |
| Mount Type | 2 Bolt |
| Paint/Packaging | Primer Low Gloss Black, Individual Box |
| Motor Type | Spool Valve |
| Mounting Hole Size | 0.565 in |
| Special Features | None |
| Pilot Diameter | 3.25 in |
| Port Code | A |
| Special Features Assembly Code | 1 |
| Pressure [Max] | 1800 psi |
| Port Size | SAE-10, 7/8-14 UNF-2B |
| Shaft Type | Straight w/ Woodruff Key |
| Shaft Size & Type | 1 in x 1/4 in Straight |
| Rotation | Reverse Rotation |
| Case Drain | 0.4375-20 UNF-2B SAE O-Ring Port (End Cap) |
| Displacement (in³/rev) | 2.81 |
| Port Size & Location | SAE-10 Side |
| Port Type | SAE O-Ring |
| Maximum Speed @ Continuous Flow | 969 rpm @ 12 gal/min |
| Bolt Circle Dia. | 4.187 in |
| Flow [Max] | 12 gal/min |
| Series | H Series |
| Port Location | Side Port |
| Case Drain Code | 1 |
| Mounting Holes | 0.535 in |
| Duty | Standard-Duty |
| Seal Material | Buna-N |
| Material | Cast Iron |
| Inlet Pressure [Max] | 2500 psi |
| Mounting Type Code | A |
| Paint Code | A |
| Output Shaft Code | 01 |
| Flow Rate | 11.25 gal/min |
| Motor Element | Gerotor |
| RPM [Max] | 969 rpm |
| Special Features Hardware Code | 00 |
| Corrosion Resistant | No |
| Splines | 0 |
| Flange Orientation | Standard |
| Weight | 13.0 LB |
