- Single Row Angular Contact Bearing, 70 mm ID x 125 mm OD x 24 mm Wide, Open, Standard Precision (ABEC 1), Brass / Bronze Cage, Normal Clearance (C0), 40° Contact Angle
features
- MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
- 7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
- 7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
- ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
- 7200-PJ and PJD Series bearings are used for heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
| O.D. | 125 mm |
| Static Load Rating [Max] | 12400 lbf |
| Bearing Type | Angular Contact |
| Inner Ring Width | 24 mm |
| Precision Level | Standard (ABEC 1) |
| Preload Level | None |
| Limiting Speed - Oil | 6000 rpm |
| Enclosure | Open |
| Snap Ring | No Snap Ring |
| Cage Material | Brass/Bronze |
| Fillet Radius | 1.5 mm |
| Capacity | Standard Capacity |
| Internal Design | Universal Mounting |
| Series | 7200PJ |
| Radial Internal Clearance | Normal |
| Flush Ground | Yes |
| icNumber | 7695856 |
| No. in Set | Single Bearing |
| I.D. | 70 mm |
| Material | Steel |
| Seal Material | None |
| Precision | Standard |
| Contact Angle | 40° |
| Radial Internal Clearance Specification | Normal Clearance |
| Locking Device | No Locking Device |
| Origin | Single Row Angular Contact |
| Inch/Metric | Metric Bore |
| Dynamic Load Rating | 14300 lbf |
| Static Load Rating | 60 kN |
| Cage Type | Metal |
| Limiting Speed - Grease | 4600 rpm |
| Outer Ring Width | 24 mm |
| Rows of Balls | Single |
| Seal Type | Unsealed |
| O.D. Type | Straight |
| Temperature Range [Max] | 450 °F |
| Lubricant | Oil Preservative |
| Ball Material | Steel |
| Bore Type | Round Bore |
| Width | 24.000 mm |
| Weight | 2.683 LB |
| EAN or UPC | 97741016711 |

