- Single Row Angular Contact Bearing, 55 mm ID x 140 mm OD x 33 mm Wide, Open, Standard Precision (ABEC 1), Brass / Bronze Cage, Normal Clearance (C0), 40° Contact Angle
features
- MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
- 7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
- 7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
- ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
- 7400-PJ and PJD Series bearings are similar to the 7200-PJ and 7300-PH Series but are heavier sectioned and are used for very heavy thrust loads or combined radial and thrust loads where thrust is predominant.
| Material | Bearing Steel |
| Preload Level | Light |
| Radial Internal Clearance Specification | Normal Clearance |
| Bearing Type | Unmounted, Angular Contact |
| Static Load Rating | 76.5 kN |
| Lubricant | Oil Preservative |
| Precision | Standard |
| Enclosure | Open |
| O.D. Type | Cylindrical |
| No. in Set | Single Bearing |
| Dynamic Load Rating | 111 kN |
| Locking Device | No Locking Device |
| Origin | Single Row Angular Contact |
| Cage Type | Metal |
| Precision Level | Standard (ABEC 1) |
| Inner Ring Width | 1.3 in, 33 mm |
| Limiting Speed - Oil | 5800 rpm |
| I.D. | 2.17 in, 55 mm |
| Temperature Range [Max] | 450 °F |
| Snap Ring | No Snap Ring |
| Internal Design | Universal Mounting |
| Flush Ground | Yes |
| Seal Material | None |
| Contact Angle | 40 Degree |
| Capacity | Standard Capacity |
| Static Load Rating [Max] | 17500 lbf |
| Width | 1.3 in, 33 mm |
| Inch/Metric | Metric |
| Fillet Radius | 2 mm |
| Cage Material | Brass |
| Outer Ring Width | 1.3 in, 33 mm |
| Radial Internal Clearance | Normal |
| O.D. | 5.51 in, 140 mm |
| Limiting Speed - Grease | 4500 rpm |
| Ball Material | Steel |
| Seal Type | Unsealed |
| Series | 7400PJ |
| icNumber | 7695840 |
| Rows of Balls | Single |
| Bore Type | Cylindrical |
| Weight | 5.842 LB |
| EAN or UPC | 97741018463 |

