- Single Row Angular Contact Bearing, 50 mm ID x 110 mm OD x 27 mm Wide, Open, Standard Precision (ABEC 1), Brass / Bronze Cage, Normal Clearance (C0), 40° Contact Angle
features
- MRC angular contact bearings with a PJ suffix have one heavy race shoulder on the outer ring, opposing one heavy race shoulder and on recessed race shoulder on the inner ring. Because of this construction, it is possible for this bearing to incorporate a
- 7000-PJ bearings are particularly suitable for positions where the thrust is always present in one direction. It should not be used where the bearing is subjected to radial load only, or combined radial and thrust load where the radial load is predominant
- 7000-PJ bearings are available with either peressed brass or machined brass, ball centered cages. The low shoulder diameters on the nonthrust sides of inner and outer rings, combined with large clearances between the land diameters and the cage, allow fo
- ABEC Grade 3 bore tolerances reduce the range of interference fits between the shaft and bearing bore. These tighter tolerances result in closer control of preload and minimize the risk of thermal runaway.
- 7300-PJ and PJD Series bearings are used for very heavy one-directional thrust loads or combined radial and thrust loads where thrust is predominant.
| Inch/Metric | Metric Bore |
| Static Load Rating | 51 kN |
| Origin | Single Row Angular Contact |
| O.D. Type | Straight |
| I.D. | 50 mm |
| Temperature Range [Max] | 450 °F |
| Static Load Rating [Max] | 11900 lbf |
| Preload Level | None |
| No. in Set | Single Bearing |
| Radial Internal Clearance Specification | Normal Clearance |
| Width | 27.000 mm |
| Locking Device | No Locking Device |
| Seal Type | Unsealed |
| Enclosure | Open |
| Seal Material | None |
| Ball Material | Steel |
| Rows of Balls | Single |
| Dynamic Load Rating | 16700 lbf |
| Snap Ring | No Snap Ring |
| Outer Ring Width | 27 mm |
| Lubricant | Oil Preservative |
| Bore Type | Round Bore |
| O.D. | 110 mm |
| Precision | Standard |
| Limiting Speed - Oil | 7500 rpm |
| Cage Type | Metal |
| Contact Angle | 40° |
| Precision Level | Standard (ABEC 1) |
| Bearing Type | Angular Contact |
| Series | 7300PJ |
| icNumber | 7695806 |
| Capacity | Standard Capacity |
| Inner Ring Width | 27 mm |
| Material | Steel |
| Fillet Radius | 2 mm |
| Radial Internal Clearance | Normal |
| Flush Ground | Yes |
| Cage Material | Brass/Bronze |
| Limiting Speed - Grease | 5800 rpm |
| Weight | 2.632 LB |
| EAN or UPC | 97741036177 |

